How do I reset my bulldog remote start?

How to Troubleshoot the Bulldog Remote Starter

  1. Open the hood of your car and ground the black/blue wire on the automatic starter system.
  2. Enter your car and press and hold the brake pedal with your foot.
  3. Press and hold any button on your remote unit until the system starts clicking and flashing, and then stops.

How do you program a catx4 alarm code?

Programming Procedure:

  1. Turn the ignition ON.
  2. Press and hold the valed/override button.
  3. Within 10 seconds the system will chirp/flash the parking lights (3) three times, release the button.
  4. Press Button 1 of each transmitter you wish to program.
  5. Turn the Ignition OFF to exit programming.

How do I reset my alarm code?

Code Alarm Reset Procedure

  1. Make sure the security system is disarmed and the ignition is off.
  2. Without starting the vehicle, turn the ignition ON, OFF, then ON, at 1/2-second intervals.
  3. Wait 5 seconds.
  4. Repeat step 3 for any additional remote transmitters.
  5. Exit the Transmitter Programming Mode by turning the vehicle ignition on, then off.

Is it hard to install remote start?

Remote starters are convenient, inexpensive and easy to install. Install a remote starter for your car yourself. It’s a great upgrade, inexpensive and a project you can do yourself with simple tools and the supplied wiring diagram.

You might be interested:  What Ivy League School Has A Bulldog Mascot?

How much does it cost to get remote start?

There are many factors to remote car starter installation cost. In addition to the pricetag of the starter itself, you may need to purchase a bypass module to make it compatible with your vehicle. Generally, you can expect anywhere from $150 to $500 for professional installation of a remote car starter.

How much does Best Buy charge for remote start?

It sounds like you may be looking at the service itself on our website. That is the $149. There are plenty of options available to you that would work in this vehicle. When purchasing one of the kits, it may also come with free installation!

Where is the valet override button?

Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel.

What do you do if your remote start doesn’t work?

Too Many Remote Start Attempts If you have used the remote starter twice in quick succession, it will not work. Simply insert the key in the ignition and turn it ‘on’ and ‘off’. Exit the vehicle with the fob and retry step #1.

How do you get code alarm out of valet mode?

Turn the ignition key to the ON position. Within 10 seconds, press and release the valet push button switch. The alarm system will stop sounding and enter the (by-passed) mode.

Leave a Reply

Your email address will not be published. Required fields are marked *